Korg RK-100S 2 Manual Del Usuario página 13

Controlling the pitch
There are two control methods.
Tip: The range and direction in which the pitch is adjusted
with the long ribbon controller can be specified with the
sound editor software (when the RK-100S 2 is connected
to a computer via USB).
Controlling the pitch of the continuant
2
1
1. Select the program.
In this case, select a program where the sound does
not immediately decay to silence after a keyboard
key is pressed.
There may be no effect with a program where
the sound immediately decays to silence after a
keyboard key is pressed
2. While a sound is being produced, hold down the
LONG RIBBON PITCH/HOLD button.
The PITCH/HOLD button is lit up. Sound continues
to be produced while the button is held down.
3. Use the ribbon to control the pitch.
Slide your finger to the left and right along the
ribbon controller. With the original pitch at the
location first touched in the ribbon, raise and lower
the pitch by moving your finger in either direction.
Removing your finger from the ribbon will return
the pitch to the original setting.
Original pitch
4. Remove your finger from the button to stop the
continuant.
Controlling the pitch with your left hand free
1
1. While no sound is being produced, hold down the
SHIFT button and press the LONG RIBBON PITCH/
HOLD button.
The PITCH/HOLD button is lit up.
2
3
1
2
3
Selecting and playing a program
2. Play the keyboard.
Sound continues to be produced.
3. Use the ribbon to control the pitch.
See page 13 "Controlling the pitch of the
continuant"
If the pitch was raised with the OCTAVE button, the
sound may be difficult to hear, depending on the
area used on the ribbon.
4. Press the PITCH/HOLD button again to turn off the
button and stop the continuant.
Controlling the filter
As with pitch control, there are two control methods.
Tip: The effects that can be controlled with the long ribbon
controller can be specified with the sound editor software
(when the RK-100S 2 is connected to a computer via USB).
The filtering effect can be adjusted in the Long Ribbon section
of the sound editor software. In the Virtual Patch section, set
"Source" to "Long Ribbon", and use "Destination" to specify
the parameters to be controlled. The parameters to be con-
trolled can also be specified with Fx Long Ribbon assignments.
Controlling the filter of the continuant
1
1. While a sound is being produced, hold down the
LONG RIBBON FILTER/HOLD button.
The FILTER/HOLD button is lit up.
Sound continues to be produced while the button is
held down.
2. Use the ribbon.
Slide your finger to the left and right along the
ribbon controller. With the original sound at the
left end of the ribbon, apply modulation by moving
your finger to the other end. Removing your finger
from the ribbon will return the sound to the original
setting.
Original sound
Note: The changes in the effect parameters differ de-
pending on the settings.
3. Remove your finger from the button to stop the
continuant.
1
2
13