Courtyard Creations RTS487G Instrucciones De Ensamblaje página 3

ASSEMBLY (Note: When fastening with nuts
and bolts, always use a washer (#21 or #22)
between the tube and the bolt or the tube and
the nut.)
Step 1:
Fasten the front and the rear upright supports
(#2 and #3) at the top by using bolts (#15),
washers (#21), and plastic nuts (#24). Repeat
the same procedure for both sides. Keep the
bolts loose. See Fig. A – Step 1.
Step 2:
At both ends, insert the assembled upright
supports (#2 and #3) into the top cross beam
w/adjustable teeth (#1). Tighten all of the nuts
and bolts now. See Fig. A – Step 2.
Step 3:
Fasten the lateral cross braces (#4) to upright
supports (#2 and #3) by using bolts (#17),
washers (#22), and plastic nuts (#25).
Repeat the same procedure for both sides.
See Fig. A – Step 3.
Step 4:
Fasten the rear cross brace (#5) to the rear
upright supports (#3) by using bolts (#18),
washers (#22), and plastic nuts (#25). Tighten
all of the nuts and bolts. See Fig. A – Step 4.
Step 5:
Insert the leg caps (#12) into all of the base feet.
See Fig. A – Step 5.
V-3
15
15
Step 1
Fig. A
DO NOT RETURN TO THE STORE!
STOP
PAGE 3 OF 8
21 21 24
24
21
21
3
2
Do not tighten the bolts
after step 1. Fasten all
of the bolts after step 5.
Step 3
3
2
4
Step 4
3
5
3
2
12
12
1
Step 2
3
2
25
22
3
2
4
3
22
18
Step 5
3
2
12
12
3
2
22
17
25
22