Installation Steps - Weather Guard 9984301 Manual De Instalación

INSTALLATION MANUAL
Shelf Mounted Accessory
VAN STORAGE SOLUTIONS
FOR THE WAY YOU WORK WWW.WEATHERGUARD.COM
TM
ATTENTION: PLEASE READ AND UNDERSTAND ALL INSTRUCTIONS AND WARNINGS
BEFORE ASSEMBLING, INSTALLING OR USING THIS PRODUCT.

INSTALLATION STEPS

STEP 1. Position accessory near shelf and
determine which set of shelf mounting holes
to use.
STEP 2. turn the accessory upside down.
STEP 3. Insert u-clips, flat side facing out, into
positions that line up with the shelf mounting
holes.
STEP 4. attach mounting rails to accessory using
the 1/4-20 x 3/4" mounting bolts and u-clips.
STEP 5. turn accessory right-side up and
position mounting pins through holes on the rear
of the shelf.
STEP 6. Lower the accessory into position
aligning the mounting tabs inside the shelf.
STEP 7. attach the accessory to the shelf
using the 1/4-20 x 3/4" mounting bolts. tighten to
18 in-lbs.
Note: Mounting hardware is included if you
want to stack units.
Part No. 24-0302 REV. C ECN 5305 04/13
2