Testing Your Fan - Craftmade Forza FZA52BNK5C1 Guia De Instalacion

9. Light Kit Assembly. (cont).
Raise glass shade in order to guide pull chains
through corresponding holes. Align threaded rod
with hole in middle of glass shade and push up
gently allowing threaded rod to come through
hole. (Be sure pull chain on switch housing for fan
operation does not rub against bulbs during
operation.) Secure glass shade with threaded
washer. Do NOT overtighten threaded washer as
glass may crack or break.
Align hole in center of finial plate with threaded
rod, allowing pull chains to come through
corresponding holes in finial plate, and push up.
Thread center pull chain through hole in finial
and re-attach finial. Do NOT overtighten finial as
glass may crack or break.

10. Testing Your Fan.

It is recommended that you test fan before
finalizing installation. Restore power from circuit
box and light switch (if applicable). Test fan speeds
with the pull chain located on the switch housing.
Start at the OFF position (no blade movement).
First pull will set the fan to HI. Second pull will set
the fan to MEDIUM. Third pull will set the fan to
LOW. Fourth pull will again will set the fan to OFF
setting. Test light with pull chain in the middle
(diagram 1). If fan and/or light do (does) not
function, please refer to "Troubleshooting" section
to solve any issues before contacting Customer
Service.
Turn fan completely off before moving the reverse
switch. Set reverse switch to recirculate air
depending on the season:
- LEFT position in summer (diagram 2)
- RIGHT position in winter (diagram 3)
A ceiling fan will allow you to raise your thermostat
setting in summer and lower your thermostat
setting in winter without feeling a difference in
your comfort.
Important: Reverse switch must be set either
completely to the LEFT or completely to the RIGHT for
fan to function. If the reverse switch is set in the
middle position (diagram 4), fan will not operate.
Attach pull chain extensions supplied or custom
pull chain extensions (sold separately) to the ends
of the pull chains.
threaded
rod
finial
reverse
switch
chain extension
diagram 1
diagram 2
page 8
motor housing
switch housing
threaded washer
finial plate
motor housing
motor housing
light pull
fan pull chain
extension
diagram 3 diagram 4
glass
shade