Fan Assembly; Motor Housing Assembly - Litex Industries BNH44NI5C1S Guia De Instalacion

6. Fan Assembly.

Remove motor assembly from j-hook on
mounting plate. Lift motor assembly to
mounting plate and carefully push wiring
and wire connectors into outlet box. Align
holes in top of motor assembly with bolts
in mounting plate and push up so that
bolts come through holes. Secure motor
assembly with flat washers and motor
mounting nuts that were previously
removed (refer to page 3, Section 4).

7. Motor Housing Assembly.

Hold motor housing up to mounting plate
to determine which 2 screws in mounting
plate align with slotted holes on top rim of
motor housing. Put motor housing down
and partially loosen the 2 screws in the
mounting plate that correspond to slotted
holes in the motor housing. Remove the
other 2 screws from the mounting plate.
Now, raise motor housing to mounting
plate again, allowing slotted holes in
motor housing to align with loosened
screws in mounting plate. Twist motor
housing to lock. Re-insert the 2 screws that
were previously removed and then tighten
all screws to secure motor housing.
j-hook
motor
mounting
nuts and
flat washers
motor assembly
slotted hole
motor
housing
page 5
mounting
plate
motor
mounting
nuts and flat
washers
mounting
plate
motor
assembly
motor
housing
screws