Mount The Freezer And Refrigerator Compartment Doors; Water Supply Installation - LG LSC 27950SW Guía De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation
Pass the refrigerator laterally through the access
Pass the
refrigerator
door as shown in the right figure.
Mount the freezer and refrigerator
compartment doors

Water supply installation

Before
installation
Warning
Disposal of the
This appliance contains fluids (refrigerant and lubricant) and is made of parts and
old appliance
materials which are reusable and/or recyclable.
All the important materials should be sent to the collection center of waste material
and can be reused after rework (recycling). For recycling, please contact the local
agency.
7
Mount them in the reverse sequence of removal after they pass through the access
door.
Automatic icemaker operation needs water pressure of 21~121 psi (1.5~8.5
kgf/cm
2
) (That is, an instant paper cup (6 oz. or 180 cc) will be fully filled within
3 seconds.)
If water pressure does not reach the rating 21 psi (1.5 kgf/cm
necessary to purchase a separate pressure pump for normal automatic icing and
cool water feed.
Keep the total length of the feed water pipe tube within 26' (8 m). Be careful for the
tube to avoid being kinked. If the tube is 26' (8 m) or longer it may cause trouble in
water feed owing to the drain water pressure.
Install the water supply line where it will not be affected by heat.
Connect to potable water supply only.
Max
5
4
3
2
1
Min
FRZ
TEMP
1
2
5
3
4
TEMP
REF
Max
) or below, it is
2

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Lsc 27950sbLs c27950stLsc 27960st

Tabla de contenido