Publicidad
GB
1. Install the front wheel
● Use the Spanner (15) to loose the nut (C), gasket (B) and boot cap for nut (D) from the front
axle (A) in a counterclockwise direction. (The boot cap using for protecting the nut from
damage, please put in the recyclable dustbin).
● Install the front wheel (2), gasket (B), nut (C) onto the front axle (A), then install the wheel
cover (18) on front wheel finally.
2. Install the rear wheel
● Use the spanner (15) to loosen the nut (C) from the rear axle (12).
● Insert the rear axle (12) pass through the right motor, car body, left motor in order, keep the
same length at left and right ends.
● Insert the wheel driver (4), rear wheel (3) and nut (C) onto the rear axle (12), then install
the wheel cover (18) on rear wheel finally.
3. Install the seat
Put the seat (7) onto the right place (align the 3 hook on the front of seat to the right place on
car body, as shown in figure), then fix the seat with 2 pcs. self-tapping screw (14), as shown in
figure.
4. Install the steering wheel
4.1 Remove the screw from the steering wheel (1) firstly.
4.2 Insert the steering wheel on steering yoke, as shown in figure, then insert the screw back
to the steering wheel.
5. Install the trailer
5.1 Use the spanner (15) to loosen the nut and gasket from the axle of trailer (11).
Install the axle of trailer into the trailer body part (6) as shown in figure.
5.2 Insert the axle sleeve, wheel of treiler, gasket and nut onto the axle of trailer, then install
the wheel cover on wheel of trailer finally.
5.3 Turn over the trailer frame firstly, then align the 6 hole of trailer with the 6 salient point on
trailer frame and press it hardly (Keep the arrow in the same direction, L to the L, R to the
R). Make sure it has reached the designed position.
Install the trailer in correct direction follow as figure 1.
5.4 Install the tailer guard and sprade, trailer guardrail - front part and trailer guardrail, as
shown in figure.
5.5 Insert the trailer guardrail onto the trailer frame as shont in figure (align the 10 hooks with
the 10 groove and press it).
5.6 Install the trailer: Align the car button hole with the bolt at the car and press it hardly.
Remove the trailer: Keep pressing the button on the bar firstly, then lift the bar to remove it.
6. Connect the power
6.1 Use coin or screwdriver to loosen the knob on the hood in counterclockwise direction,
6.2 Open the hood
6.3 Connect power port [1] to the motor terminal to power the car [2].
6.4 Put back the hood and use cooin or screwdriver to tighten it in clockwise direction.
2
1
2
3
4
Soundboard
1. Voltage display
Attention!
Your vehicle displays the total voltage of the two batteries in volts immediately after switching on.
The fully charged batteries will usually display a total voltage of approx. 12.6-13 volts unloaded.
The display is load dependent. This means that the displayed voltage will drop under load. If a
voltage of less than approx. 11.8V is displayed in the unloaded state, you should switch off the
Ride-on and charge the battery (see charging procedure). Otherwise the battery may be deeply
discharged and irretrievably damaged.
2. Previous Music/Volume -
Press = previous, long press = Volume down
Only use in direct supervision of an adult!
To control the vehicle a minimum skill level and caution is needed. Make sure you
are familiar with the operation of the model and its characteristics. The model is
heavy. This is an increased risk of injury and damage in the event of loss of control.
Avoid any kind of intentional or unintentional collisions with objects or hazards to
persons.
1
3
4
6
5
6
5
7
7. Placing the battery in the steering wheel
Open the battery cover on the front of the steering wheel. Put 2 AA batteries making sure that it
is correctly put in. Then close the cover.
8. Charging Your Vehicle
• The power swich must be turned in OFF position when charging.
• The charging port is under the seat.
• Insert the charger into the socket - the LED lights up green. Connect the charger to the
charging socket.
• The LED on your charger lights up red as long as the battery is being charged. If the LED
lights green again, the battery is fully charged.
• The charge time is 9 hours.
• When the vehicle begins to run slowly, recharge thebattery.
• Do not charge the battery more than once within 24 hours.
• Charger and battery heat up during the charging process.
Warning!
• Let the model cool off sufficiently after each use before putting it back into operation.
When using an additional batteries let it cool off for minimum 15 minutes until the
model is operated again. Overheating can damage the electronics or may result in fire.
• Always disconnect the model from the charger immediately after charging. Always
disconnect the charger from the power supply immediately after disconnecting the
model. Inserting the rechargeable model or charger after charging will result in damage
tothe model, charger or the power supply (fire hazard).
Resettable fuse
The vehicle is equipped with a self-resetting fuse. When the
current exceeds a certain rating, the recoverable fuse will au-
tomatically cut off the power supply for 5 - 10 seconds, then
the current will be resupplied.
Warning!
Risk of fire. Do not bypass fuse. This may overload and
damage the elecrical system. Replace only with original
size and type.
Functions
1. Power switch
Turn on or turn off the power.
2. Horn button
Press the button to play the horn.
3. Soundboard
4. Speed button
High speed
Change the speed of the car more quickly.
Low speed
Change the speed of the car more slowly
5. Shift Lever
Forward:
Press the "Forward-backward switch" on the "Forward" position.
Press the "Foot pedal", the model drives forward.
Reverse:
Press the "Forward-backward switch" on the "Backward" position.
Press the "Foot pedal", the model drives backward.
Important!
The vehicle must be stationary before changing direction or speed. Otherwise the gear
unit and/or the motor could be damaged.
6. Foot pedal
To move the car, press the pedal down.
To brake or slow down, release pressure from the pedal.
3. Pause/play
Press short = Pause, long press = in FM mode, this botton will search radio station.
4. Previous Music/Volume +
Press = Next, long press = Volume up
5. Mode switch button
Can swith between different play modes.
6. AUX connector
Input for a Smartphone or other AUX devices.
7. USB
After inserting a USB stick, the soundboard starts playing the tracks one after the other. Only
files with the extension .mp3 can be played back.
Battery warning:
Non-rechargeable batteries are not to be recharged!
Do not open! Do not dispose of in fire!
Do not mix old and new batteries!
Do not mix alkaline batteries, standard (carbon-zinc) or rechargeable batteries!
Rechargeable batteries are to be removed from the toy before being charged!
Rechargeable batteries are only to be charged under adult supervision!
The supply terminals are not to be short-circuite
7
Publicidad
