EGO ABK4200 Manual Del Operador página 6

3. Adjust the deck-height-adjustment lever to
the lowest cutting height position (Fig. 1a).
4. Disconnect both blade motor cables (Fig.
1a).
5. Place a rug or a mat (similar in size to that
of the deck) under the deck to prevent the
damage to the deck.
6. Remove the cotter pins and push the
shaft pins out. Save both sets for deck re-
assembly (Fig. 1a & b & c).
7. Push the deck forward (towards the front
wheels) and rotate the suspension linkage
counterclockwise to release it from the
deck hooks (Fig. 1a).
8. Push the deck sideways and remove it
from under the mower (Fig. 2).
9. Reverse the deck on the ground with
blades facing upward.
10. While wearing protective gloves, place a
screwdriver or metal rod with diameter
less than 5/16 in (8 mm) into the fixing
hole in the motor to act as a stabilizer.
Place another metal rod with diameter less
than 1/4 in (6.35 mm) (e.g., a bit) into the
aligned hole in the blade and the flange to
act as another stabilizer (Fig. 3).
11. Use a 9/16 in (14mm) adjustable wrench or
socket wrench (not included) to turn the blade bolt counterclockwise to loosen it
(Fig. 3).
12. While wearing protective gloves, remove the bolt, washer and the blade (Fig. 4).
The flange can be saved on the motor shaft.
To Install the Cutting Blade
WARNING: Always protect your hands by wearing heavy gloves or wrapping the
cutting edges with rags or other materials when performing any maintenance on the
mower blade. Always remove the battery packs when servicing or transporting the
mower.
NOTICE: To re-install or replace the blade, make sure that all parts are replaced in the exact order in which they are
removed (Fig. 4).
6
GRASS BAGGER KIT — ABK4200
D e c k - H e i g h t -
1a
Adjustment Lever
Suspension Linkage
1b
Right side
2
Blade Motor
Cotter Pin
Shaft Pin
Deck Hook
Deck
1
Motor Cable
2
4
1c
3
Stabilizer 1#
4
Fill with Grease
Bolt
Washer
Blade
Flange
Motor Shaft
Cotter Pin
3
Left side
Stabilizer 2#