About Remaining Battery Indicator; Maintenance And Inspection - HIKOKI RP 3608DB(L) Instrucciones De Manejo

English
○ When disconnected, this product will return to search
status.
Turn Auto OFF
Switching Auto OFF using the product
Pressing the Auto/Manual switch of the product will
activate Manual mode and break the connection.
When the connection is broken, the Auto mode of the
electric power tool will be automatically switch OFF.
This Product (Fig. 23)
Auto OFF (Manual mode)
* Auto mode can be switched OFF by switching off the
product's power.
Switching Auto OFF using the electric power tool
A long press of the wireless link switch of the electric power
tool will switch to Manual mode, cutting the connection.
When the connection is cut, the electric power tool will
automatically begin searching.
This Product (Fig. 25)
Connection OFF
(Searching)
ABOUT REMAINING BATTERY
INDICATOR
Remaining battery power can be verifi ed with either the
battery or with the cleaner itself. (Fig. 27)
NOTE
○ The reading for the remaining battery power may diff er
on the battery from that of the cleaner.
○ Use the remaining battery power as a guideline since
the readings may somewhat diff er due to surrounding
temperature or battery feature.
○ Verify the cleaner's remaining battery power when the
product is powered OFF.
Safeguard Function
Overload Protection
Temperature Protection

MAINTENANCE AND INSPECTION

WARNING
○ For inspection and maintenance, be sure to turn off the
vacuum switch and disconnect the battery.
○ Do not work with wet hands. May cause electric shock
or injuries.
1. Filter maintenance
To maintain the product's suction power, frequently
remove any attached dust from the dust fi lter, prefi lter,
cloth fi lter or fi lter damper. (Fig. 10)
(1) Gently tap by hand to remove dust from the prefi lter,
cloth fi lter and fi lter damper. Using compressed air will
make the task easier.
Bluetooth Compatible
Product (Fig. 24)
Connection OFF (Auto
OFF (Manual mode))
Bluetooth Compatible
Product (Fig. 26)
Auto OFF (Manual mode)
LED Light Display
On 0.1 second/off 0.1 second
On 0.5 second/off 0.5 second
HOW TO RECHARGE USB DEVICE
(UC18YSL3)
(1) Select a charging method
○ Charging a USB device from a electrical outlet
(Fig. 28-a)
○ Charging a USB device and battery from a electrical
outlet (Fig. 28-b)
(2) How to recharge USB device (Fig. 29)
(3) When charging of USB device is completed (Fig. 30)
LED LIGHT WARNING SIGNALS
(Fig. 31)
This product features functions that are designed to protect
the tool itself as well as the battery. If any of the safeguard
functions activate during operation, the mode display
lamp indicates this by blinking for about 30 seconds as
described in Table 3.
In this case, follow the instructions described under
corrective action.
Table 3
Remove the cause of the overloading.
Allow the tool and battery to thoroughly cool.
(2) For the dust fi lter, use a brush or compressed air to
clean.
Regularly wash off any dust from the dust fi lter with
water once every month or two months.
After washing the fi lter, suffi ciently dry it in the shade
and use the fi lter once again.
NOTE
○ Even if the prefi lter is clogged, gently tap it to clear
away dust.
Scrubbing it with a brush or other tool will only shorten
its lifespan.
○ Do not infl ict impact on the dust fi lter.
Doing so may crack the resin portion of the fi lter.
18
Mode display lamp
Fig. 31
Corrective Action