K'Nex 11413 Manual De Instrucciones página 3

BUILDING
BASICS
CAUTION: Keep hands, face, hair and clothing away
from all moving parts.
Start Building
To begin your model, find the
Each piece has its own shape and color. Just look at the
pictures, find the pieces in your set that match and then
connect them together. Try to face your model in the same
direction as the instructions while you build. The arrows
show you where the parts connect, but not all connections
points have arrows. Faded colors show you this section is
already built.
2
1
Connectors
You can slide these special connectors
together. Push tightly until you hear
a "click". Pay close attention to the
instructions and position them
horizontally or vertically exactly as
they are shown.
1 and follow the numbers.
3
-
1 2
BATTERY INFORMATION
CAUTION:
• Be sure to insert the batteries correctly
and always follow the toy and battery
manufacturers' instructions.
• Do not mix old and new batteries
or alkaline, standard (carbon-zinc) or
rechargeable (nickel-cadmium) batteries.
Only batteries of the same or equivalent
type recommended should be used.
• Always remove weak or dead batteries
from the product; do not short-circuit
supply terminals.
• Insert batteries with correct polarity (+/-)
as shown.
Important Tips
• Alkaline batteries are recommended.
• Rechargeable batteries are not
recommended.
• Remove rechargeable batteries from toy
before charging; they must be charged
only under adult supervision.
• Non-rechargeable batteries must not be
recharged.
• Keep components free of dust; do not
immerse or use in water.
• Do not dispose of batteries in a fire; they
could leak or explode and cause injury.
• Remove all batteries if the toy will not be
used for a long period of time.
• Do not put rods smaller than 2 inches
in any openings of the motor; they will
damage the motor, and cannot be
removed.
• Help the environment by disposing of
your product and packaging responsibly.
The wheelie bin symbol indicates that
the product and batteries must not be
disposed of in the domestic waste as
they contain substances which can be
damaging to the environment and health.
Please use designated collection points
or recycling facilities when disposing of
the item or batteries.
How to Insert
and Remove
Batteries
Use a small Phillips head
screwdriver to loosen
the screw. Insert 2 fresh
AA batteries (LR6) into
the compartment with
the correct polarity (+/-)
as shown here.
Flexi-rods
A Flexi-rod is a rod that you bend
to make curves. It will be easier to
attach to your model if you bend it
back and forth first.
3