LawnMaster GT1450 Manual Del Usuario página 12

ASSEMBLY
PREPARING THE TRIMMER FOR USE
1.Attach the outlet end of an extension cord to the plug on the rear of the grass trimmer.
NOTE:
Use only approved outdoor extension cords.
2. Route the extension cord through the slot located on the rear of the grass trimmer housing and
place underneath the cord retainer.
3. To start the grass trimmer, press the switch trigger.
4. To stop the grass trimmer, release the switch trigger.
WARNING
If any parts are damaged or missing, do not operate this product until the
parts are replaced. Failure to heed this warning could result in serious
personal injury.
WARNING
Do not connect to power supply until assembly is complete.
Failure to comply could result in accidental starting and possible serious
personal injury.
WARNING
Never attempt to lock the switch trigger in the ON position.
(See Figure 10 & Figure 11.)
Fig.10
12
Fig.11