flir Raymarine Guia De Inicio Rapido página 8

Quick start guide for Remote Display
To enter the active page: Press the
current settings is displayed with the active parameter over the cursor
Press the
To change the active parameter: Press the
the desired parameter title is over the cursor
To edit a numeric parameter value: Press the
will begin to flash. Use the
the button again to set the new value.
To reset a memory value: Press the
To select a parameter option from a list: Press the
parameter option will begin to flash. Use the
the option required. Press the
To toggle between ON/OFF parameter settings: Press the
Troubleshooting
Lost Network Alarm sounds:
Check that the master display is working correctly and that the
affected display(s) are within range.
No Volts alarm sounds:
Check that the Hull Transmitter and Wireless (NMEA) interface
are connected to a 9 to 30V DC supply.
Low Battery Alarm sounds:
Go to Setup/Health and check the battery level for the Hull
Transmitter/Wireless (NMEA) Interface/Wind Transmitter as
indicated by the alarm display. Charge or place in bright sunlight
if required.
Power Save Alarm sounds:
There is no data activity on the network, the system will close
down to save power. Press any button to cancel.
6
button to return to the list of pages.
and
button. A list of parameters and
button repeatedly until
.
button. The value data
buttons to adjust the value. Press
button.
and
button again to set the new option.
button. The
buttons to select
button.
www.raymarine.com
.