BDS 68345 Manual De Instrucciones página 5

OPERATION
to disassemble the
puller barrel injectors,
to use as T10133 / 1
to disassemble the
puller claw injectors,
to use as T10133/2
to disassemble the
gliding
injectors,
hammer
to use as T10133/3
to mount the combustion
assembly cone chamber sealing rings,
to use as T10133/5
for pushing the combustion
calibrating
chamber sealing rings,
barrel
to use as T10133/6
1st step
for narrowing the
calibrating
combustion chamber
barrel
sealing rings
to use as T10133/7
2 nd step
for narrowing the
calibrating
combustion chamber
barrel
sealing rings,
to use as T10133/8
to mount the fuel injectors,
fitting pin
to use as T10133/9
Caution:
•
Combustion chamber sealing ring set up without using of oil.
•
By mounting the sealing rings on the assembly cone this to be
expanded. After assembly, combustion chamber sealing rings must
therefore be narrowed in two steps with the calibrating barrel again.
•
This manual is only to show how to operate with this tool and it is
not replace the service literature.
•
For repair, adjustment and inspection work always use appropriate
service literature, so you avoid erroneous diagnoses and incorrect
settings that can lead to engine damage
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
FSI-Engine
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
180°
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed