Saivod TMS158 Manual Del Usuario página 31

OPERATING INSTRUCTIONS
 Water Entering: After fixing all the pipes, then make the cold and
heat water-blending valve rotate to the high temperature sector
according to the clockwise direction. And reopen the cold water
pipe's water pipe's water entering valve. At this time, the electric
water heater's tank will start to enter the water. Waiting that the
shower sector of the water exiting mouth is in normalcondition,
which indicates that the tank has fully filled with water.
Cautions: During the electric water heater is in the normal operating
procedures, the water-entering valve of the cold water pipe's mouth-en-
tering sector must be in the open condition from the beginning to the
end .At this time, the water-entering valve can still make the functions of regulating the
water-existing mouth section's flowing strength and weakness. However, the cold and hot
mixed water valve can only regulate the water temperatures and make the function of clos-
ing the water existing.
 Putting through the power: After confirming the tank to be fully filled the water, you can
make the power source's plug insert into the outlet and put through the power sources.
 Hot water operations: After the electric water heater normally works and heats for a
long period of time, you can use the hot water in the tank, you need to make the cold
and hot mixed valve rotate with the clockwise direction slowly from the low tempera-
ture to the high temperatures in the closed condition. And adjust it to your proper tem-
perature. At that time, the shower mouth can come out the hot water. After finishing the
uses, you can turn it to the closed section by the anti-clockwise direction and shut off
the mixed water valve.
 Cautions: When adjusting the water temperature of the water-existing mouth, you don't
make the shower directly to the human body; you should test the water temperature
first to avoid burning to damages.
 Overheating Protections: Under the condition of putting through the power, but the
heating pipe won't heat from the beginning from the end. At this time, it may appear
the over heat protections (that is to make functions by the double-positional tempera-
ture-limiting protection switch).
 Automatically balance the temperatures: when the water temperature in the tank reach-
es the set one, it will automatically cut off the power and halt heating. Meanwhile, the
heating indicator will put out. The electric water heater will be in the temperature-main-
taining condition. When the water temperature in the tank reduces to a certain one, It
will automatically begin to heat. After reaching the temperature-keeping condition. It
will circulate to automatically work like these.
OPERATING GUIDES
Temperature setting: According to your required temperature, rotate the temperature-ad-
justing knob by the clockwise direction. You can select to use the heating temperatures
without grades in the temperature ranges of twenty to seventy-five degrees Celsius from
closing to the low, medium and high bands or from low to high.
DAILY AND COMMON MAINTENANCES
 Frequently checking the connection of power source's plug and the outlet is in good
condition. Reliable, whether heating. The plug's outlet is well connected the ground or
not.
TMS158.indd 31
GB
31
2018/3/23 10:09:24