Product Structure - Saivod TMS158 Manual Del Usuario

SECURITY CHARACTERISTICS
 Security Valve: This electric water heater fits a mono-directional security valve. It must
be installed at the water entering hole sector of this unit of the electric water heater.
When the tank's pressure is over 0.8MPa, this valve will automatically leak the pressure.
It may exist the water drops to fall down at the pressure leakage mouth sector. In any
conditions, this pressure leakage mouth must not to be blocked. You must keep it an-
ti-through with the atmosphere.( Diagram 1)
Note: For the interior-ventilating styled security valve, its pressure leakage exit sector may
not exits the water drops to drip down. Otherwise, during the heating procedure, the wa-
ter-entering pipe's outer cover under the safety valve may have a certain temperature. This
belongs to the normal conditions. This indicates that it is internally-draining the leakage
pressure.
 To drain the tank perform the following steps :
If needing to make the tank empty, firstly close the water-entering valve door, open the wa-
ter-exiting valve door. Then tear down the fixed screw nails on the security valve with tools.
Make the plastic handle lift up; let the water in the tank naturally flow out.
(Diagram 2)
TECHNICAL REFERENCE DATA
Rated Voltage
Rated Frequency
Rated Pressure
Rated Water Tempera-
ture
Water-proof Degree

PRODUCT STRUCTURE

28
TMS158.indd 28
Diagram 1
220-240 V~ Rated Power
50/60Hz Rated Volume
0.8Mpa Heating Efficiency
75℃ Structure Mode
IPX4 Fixing Mode
Diagram 2
2000W
15L
>90%
Hermetically
closed typed wa-
ter storage style
Hanging type
2018/3/23 10:09:24