Publicidad
CÓMO MONTAR LA ESCOBA
1. Encajar a presión las dos varillas
entrelazadas.
2. Empujar las varillas montadas dentro
del casquillo del mango de la escoba
de manera que los botones encajen en
su sitio.
3. Empujar el cordón dentro de los
canales.
4. Conectar el cordón de la escoba a la
conexión del tubo, alineando las
esquinas en ángulo del enchufe con el
receptáculo del tubo.
5. Encajar el extremo del tubo en las varil-
las montadas, asegurándose de que el
cierre del botón esté puesto.
6. Cuando se esté listo para usarla,
conectar el tubo a la toma de la pared
de la aspiradora y enchufar el cordón
eléctrico en cualquier tomacorrientes
conveniente de 120 voltios.
Nota: Al usar el tubo de enchufe
directo NuTone CH610 con la tomas
electrificadas de la serie CI390, el
enchufar el tubo también conecta la
corriente de 120 voltios.
Button
Botón
Anilla
giratoria
Portacordón
Cord
de la
Wand
Holder
varilla
Swivel
HOW TO USE THE POWER BRUSH
NOTE:
CT600 Power Brush is not recommended for use on bare floors. Wand
release on Power Brush allows you to quickly disconnect wands and switch
to Combination Floor/Rug Tool for use on bare floors.
Always pick up hard or sharp objects by hand before using your Power Brush.
Items such as pins, hairpins, tacks, crayons and pencil stubs may damage the
brush roll or may break a belt.
HANDLE RELEASE
Push down on Power Brush handle release pedal;
pull wand/hose assembly back to comfortable work
position. Return the handle to the upright position
for storage.
HEIGHT ADJUSTMENT
Select height setting by depressing height
adjustment pedal to desired position: Extra-Low,
Low, Medium or High.
EDGE CLEANER
Anilla giratoria
Brush extends full width for effective edge cleaning along both sides of nozzle.
de la varilla
To operate, simply run cleaner along edge board. Rubber bumper protects
furniture and baseboards.
MAINTAINING POWER BRUSH
NOTE: Disconnect power cord and wands from electrical hose before
Varilla
The instructions given in this booklet serve as a guide to routine maintenance.
To avoid unnecessary service calls, check the belt and brush roll often. Replace
the belt if it is stretched or cracked. Clean the brush roll bristles when they are
Botón de la varilla
wrapped with thread and hair. Build-up could cause the brush to rotate unevenly.
GENERAL CARE
Pedal de
liberación de
To keep the Power Brush housing clean, it can be wiped with a damp cloth and
la varilla
a mild soap solution, then thoroughly dried. Never use any type of chemical as
chemicals can damage the housing. When not in use, the Power Brush should be
stored in a clean, dry place.
The motor is permanently lubricated and sealed. Do not oil the motor at any time.
cleaning Power Brush.
Pile Height
Indicator
Height
Pile Height
Handle
Adjustment
Pedal
Release Pedal
Pedal
Publicidad
