Metalworks CAT1500 Manual página 7

CAT1500 - NLFRENES - v1.0 - 27012014
EN
To use:
Note: For this and other types of loads, make sure all connections are tight and secure before operating the hoist and
leveler.
To remove an auto or truck engine with transmission intact:
1. Uncouple the transmission and remove motor mount bolts.
2. Engine leveler should be hooked to an overhead hoist above the engine. Using one of two holes provided, attach
the L-shape connection at the end of the four chains to the head bolts, two at front, both sides and two at rear, both
sides.
3. Using the engine hoist, take up slack in chain carefully.
4. Lift a few inches and check load balance.
5. To reach desired angle for load balance, adjust the position of the movable fulcrum in the beam by turning the 1''
hex adjusting nut at the end of the worm shaft with a ratchet wrench.
6. Carefully lift out the engine and transmission.
7. By turning the handle one direction or the other, the suspended engine and transmission can then be tipped only
enough to remove.
8. Reverse the above steps to reinstall repaired engine and transmission.
Engine leveler
Spare parts: see on page 10
®
7