Maintenance And Cleaning; Electric Shock; Cable Assembly; Risk Of Injury - Binzel Abicor ABIPLAS WELD Instrucciones De Servicio

9 Maintenance and cleaning

9 Maintenance and cleaning

9.1 Cable assembly

EN - 16
Scheduled maintenance and cleaning is a prerequisite for a long life and a
trouble-free operation.
DANGER
Risk of injury due to unexpected start-up.
For the entire duration of maintenance, servicing, dismounting and repair
work, the following instructions must be adhered to:
• Switch off the power source.
• Close off the gas supply.
• Close off the compressed air supply.
• Pull the mains plug.
DANGER

Electric shock

Dangerous voltage due to defective cables.
• Check all live cables and connections for proper installation.
• Replace any damaged, deformed or worn parts.
NOTE
• The maintenance intervals given are standard values and refer to single-
shift operation.
• Maintenance and cleaning work may only be carried out by qualified
and trained specialists.
• Always wear your personal protective clothing when performing
maintenance and cleaning work.
Clean the cable assembly by proceeding as follows:
1 Check screwings and plug-type connections for visible damage and tight fit
and replace them, if necessary.
WARNING

Risk of injury

Serious injuries caused by parts swirling around.
• When cleaning with compressed air, wear suitable protective clothing, in
particular safety goggles.
®
ABIPLAS WELD