Akiyama CDX-MP250S Manual De Usuario página 17

18 . FADER START PLAYBACK. Both players' RELAY jacks are connected to
Mixer's CROSS FADER jacks via auto-start cable. When the jacks are connected,
the operation for both players as following:
Left player will return to standby mode at CUE point automatically when move
CROSS FADER from left to right to start playback on right player.
Right player will return to standby mode at CUE point automatically when move
CROSS FADER from right to left to start playback on left player.
19. RELAY FUNCTION (RELAY PLAY USING TWO PLAYERS).How to set the
Relay function:
When the both players' RELAY jacks are connected to each other, the relay-play
function can be produced. The relay play is explained as below:
- Set both players to single play mode (the SINGLE indicators will appear in the
displays).
- Begin playback on the first player.
- After the first player's single track ends, the second player's track will immediately
begin playback. The first player will enter standby mode at the beginning of the
next track on its disc.
- The relay play between these two players will continue until you stop it or power is
interrupted.
- By loading new discs on the standby player, you can construct a continuous
program of whatever tracks you wish.
- By setting a cue point on the standby player, you can perform relay to any desired
cue point on the selected track.
NOTE: Relay play may not work properly if the audio out jacks on the two players
are not connected to the same audio amplifier.
20.STUTTER EFFECT. It can create a sound similar to a CD skipping. The STUTTER
Effect can be created in 2 ways.
A. By rapidly pressing the CUE PLAY button.
B. By rapidly pressing the BANK1 or BANK 2 or BANK 3 or BANK 4 button.
21.SENSITIVITY ADJUSTMENT. Press and hold the PITCH ON/OFF button, then
turn FOLDER knob to adjust jog wheel sensitivity, range is -20 ~ +20.
TURN
DISPLAY
TR
All manuals and user guides at all-guides.com
GENERAL FUNCTIONS OVERVIEW
HOLD
Setup
Fig.11
22. START & STOP SPEED CONTROL. We can set the start and stop times at our will.
Press button SPEED AJDUST (23) and button X (24) and turn the wheel to set the
desired Start Speed. At the Display we can see the X parameter "Start Time".
PARAMETER
DISPLAY
PARAMETER VALUE OF START TIME
Press button SPEED AJDUST (23) and button Y (25) and turn the wheel to set the
desired Stop speed. At the Display we can see the Y parameter "Stop Time".
PARAMETER
DISPLAY
23. SLEEP MODE. The CD player automatically shuts off the transport and laser after
about 15 minutes when in pause or cue mode). This extends the life of your motor
drive and laser. During sleep mode the display shows the word "SLEEP". To wake
up the player, just press the cue or play button, the display turns to normal and is
ready to receive instructions.
Hold the PITCH ON/OFF button, then press down and turn FOLDER knob to
adjust sleep time, range is 1~35 minutes.
You can set the time before entering in Sleep Mode by pressing PITCH ON/OFF
button and pressing and turning FOLDER encoder. We can monitor the operation at
the Display.
PRESS + TURN
DISPLAY
TR
25
Fig.12
25
Fig.13
HOLD
Setup
Fig.14
16