Manual Time Setting - FanJu FJ3389B-NORCC Manual Del Usuario

2 INITIAL OPERATION AND NOTES
2.1 Initial Operation
► Open Weather Station battery compartment cover
► Insert 2 x AA batteries observing polarity [ "+" and " –" marks]
► When you insert the batteries, all the icon on the LCD display will briefly
light up for 3 seconds, and you will hear a beep tone, and detect indoor
temperature & humidity.
► The Weather Station will now start to make a connection to the outdoor
remote sensor. This operation takes about 3 minutes and is displayed by a
flashing reception RF antenna symbol in the "OUTDOOR" display area on
the receiver.
► This now, replace Wireless Outdoor Sensor battery compartment cover,
Open Weather Station battery compartment cover, Insert 2 x AA batteries
observing polarity [ "+" and "–" marks]
► After receiver has created a connection to the outdoor remote sensor, it
will then enters the clock mode.
2.2 Notes for Customer before Use
► If weather station failed to receive transmission from outdoor sensor ("-
-"display on the main station LCD), press and hold "▼" button for 3 seconds
to receive transmission manually. RF icon " " flashes on the LCD and the
weather station to re-receive the data from outdoor sensor. Or
sensor battery compartment, press the TX button to connect the sensor and
station again.
3 TIME AND CALENDAR SETTING

3.1 Manual Time Setting

► Press once "
► Press and hold down the "
temperature display starts to flash. Now use the "▲" and "▼" button to set
the temperature of the unit, the unit of temperature can be set to "°C" or
"°F"
► Press "
" to confirm your setting, the unit of pressure display starts to
flash. Now use the "▲" and "▼" button to set the pressure of the unit, the
unit of t pressure can be set to "hPa" or "inHg"
FJ3389B-NORCC Manual
" button, can switch the display calendar or second.
" button for 2 seconds, the unit of
5
open the