Using The Remote Control; Installing Or Replacing The Batteries - Naxa NDL-256 Manual De Operación

P/N Change between PAL, NTSC,
and AUTO video modes.
Numeric Use the keypad to enter a
Keypad number value as necessary.
(0-9, +10) Press +10 to skip forward 10
tracks.
GOTO Go to a specific time point in
a track.
PRO- Enter program mode to cre-
GRAM ate a custom playlist.
REPEAT Toggle the repeat playback
mode.
A-B Set Repeat A-B to loop a
portion of a track.
RETURN Go back.
BT PAIR Connect a Bluetooth
device.
CLEAR Cancel.
ANGLE Change the camera view
extra angles are available.
SUBTITLE Change the subtitle options.
Page 14

Using the Remote Control

Aim the IR emitter of the remote
control at the remote sensor and
then press a key. The remote con-
trol will work within 15 feet of the
remote sensor and at an angles less
than 30 degrees from the center
line.
L L
Obstacles between the
remote control and the
sensor may interfere
with the signal.
Direct sunlight, incan-
descent or flourescent
®
lamps, and other strong
light sources may inter-
fere with the signal.
Installing or Replacing the
Batteries
The remote control requires 2 x
"AAA" batteries to function. Alka-
line batteries are recommended.
1. Find the battery compartment
door the back of the remote
control. Press in on the tab to
release the door.
2. Load 2 new "AAA" size batteries
into the battery compartment.
Make sure to match the "+" and
"–" poles of the batteries with
the markings found inside the
compartment.
3. Replace the battery compart-
⚠
ment door.
L
Use only the size and
type of batteries speci-
fied.
Naxa Electronics