Technical Data; Intended Use; Safety Instructions - BGS technic 9251 Manual De Instrucciones

Floor Jack, hydraulic, 3 t, with Quick Lift Pedal

TECHNICAL DATA

Rated load: 3000 kg
Min. height: 145 mm
Max. height: 500 mm
Lifting height with rated load: 340-500 mm
Stroke: 355 mm
Length: approx. 685 mm
Weight: approx. 37.2 kg
ATTENTION
Please read these instructions carefully before using the product for the first time and store them for future
reference. This product must be operated in accordance with these instructions at all times. Make these
instructions for use accessible to all persons who will be working with this product. This applies also when
reselling the product.

INTENDED USE

This product is made for lifting motor vehicles on a firm, even surface. This product is intended for use as a
lifting device only. Ensure that the load to be lifted does not exceed the maximum permissible load of the
jack.

SAFETY INSTRUCTIONS

Please read these safety instructions carefully before using the product for the first time. Failure to heed
these warnings may result in loss of load, damage to the jack and resulting in personal injury or property
damage.
• Only use the floor jack for its intended purpose.
• Only use the floor jack for lifting and lowering vehicles. Never lift perso- ns with the floor jack!
• Always be careful and attentive when handling the floor jack. When attaching and dismantling
accessories, such as the lifting rod, watch your hands and fingers as there is a risk of crushing.
• Before the lifting procedure, secure the vehicle being lifted from rolling away unintentionally. Pull the
parking brake on and put the vehicle in gear. Secure the wheels not being lifted with suitable blocks.
• Secure the lifted vehicle from lowering unintentionally by using suitable chassis stands.
• Do not work under the lifted load as long as it is not secured by suitable means.
• Make sure that the lifted vehicle cannot move on the floor jack.
• Only use the floor jack on a firm, even and dry surface. The load can easily slip on unfirm, uneven or
damp/wet surfaces.
• Always support the vehicle in the middle part of the mounting block.
• Do not exceed the permitted rated load! The loading of the floor jack must not exceed 3.0 tonnes, as
this can be damaged if overloaded (e.g. overloading the mechanical properties) and personal safety
is therefore no longer guaranteed.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 9251
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed