Olympus LS-10S Instrucciones página 80

Symptom
Voice files are not recorded
in stereo
Cannot find the recorded
Voice File
Noise heard during playback
Unable to erase
6
Unable to hear any sound
from the earphone through
the recording monitor
Noise is audible through the
recording monitor
80
Probable cause
The connected external microphone is
monaural.
Wrong recording media or folder.
The recorder was shaken during record-
ing.
The recorder was placed near a cell
phone or fluorescent lamp while recording
or during playback.
The settings of the connected external
microphone do not correspond to those
of the recorder.
The file is locked.
The file is read-only.
The [Rec Monitor] is set to [Off].
Acoustic feedback is occurring.
Troubleshooting
Action
When recording while an external monaural
microphone is connected, sound will only be
recorded by the L-channel.
Switch to the correct recording media or
folder (☞ P.19 to P.20, P.23, P.41, P.46).
- - - - - - - -
Move the recorder.
When a microphone not supported by the
plug-in power function is connected, turn
the [Plug-inPower] setting to [Off] (☞ P.41,
P.44).
Unlock the file (☞ P.41, P.47).
Cancel the read-only setting of the file on
the PC.
Turn the [Rec Monitor] setting to [On]
(☞ P.41, P.44).
When the built-in speaker amps and the
like are connected there is a risk that audio
feedback will occur while recording. It is
recommended that you use earphones for the
recording monitor, or turn the [Rec Monitor] to
[Off] while recording (☞ P.41, P.44).
Conduct adjustments like separating the
earphones from the microphone farther, do
not point the microphone at the earphones,
lower the volume on the recording monitor,
and so on.