Electrical Connections - Allmatic B.RO X40 DISPLAY Manual Del Usuario

REMARKS
Please read this instruction manual very carefully before installing and programming your control unit.
After the installation keep this instruction in a safe place for any further consultation.
• The device must not be used by people (children included), whose physical, sensory and mental capacities are reduced, or without
experience or knowledge, unless they could benefi t through the intermediation of a person responsible for their safety, of a
surveillance or of instructions related to the use of the device.
• Children must be kept under surveillance to make sure that they do not play with the device.
• If the power supply's cable is damaged, it must be replaced by the manufacturer or by his assistance service or in any case by a
person with similar status in order to prevent any risk.
• This instruction manual is only for qualifi ed technicians, who specialize in installations and automations.
• The contents of this instruction manual do not concern the fi nal user.
• Every programming and/or every maintenance service should be done only by qualifi ed technicians.
• The installer must provide the installation of a device (es. magnetothermical switch) that ensures the omnipolar sectioning of the
equipment from the power supply.
1
DESCRIPTION
B.RO X40 Display is a 4-channels Rolling Code receiver compatible with all Allmatic Rolling Code remotes. This device has an easy
and intuitive functioning thanks to the display interface and 3 buttons. 4 relay outputs are available with dry contact normally open
(N.O.) and/or closed (N.C.). Outputs can work with 4 different modes: dead man, step by step, timed and timed with delay. Each
output can be controlled by a dedicated wired input or by a single key of a memorized transmitter. The output function is directly
associated to the input command and no to the relay.
The learning of a key of a transmitter can be realized with 3 procedures: default learning (customizable), sequential and advanced.
Power supply 12-24 Vdc/Vac with automatic selection of the voltage.
2

ELECTRICAL CONNECTIONS

CONNECTIONS
1-5: wired input (N.O. contact) for relay 1.
2-5: wired input (N.O. contact) for relay 2.
3-5: wired input (N.O. contact) for relay 3.
4-5: wired input (N.O. contact) for relay 4.
6-7:
power supply.
8-9: relay output 1 (N.O. contact).
9-10: relay output 1 (N.C. contact).
11-12: relay output 2 (N.O. contact).
2/20
DISPLAY
20 21
UP DOWN
MENU
+ -
INPUTS LED
1 2 3 4 5 6 7 8
ITA ENG FRA
RADIO MODULE
MEMORY
OUTPUTS LED
OUT1 OUT2 OUT3
9 10 11 12 13 14 15 16 17 18 19
12-13: relay output 2 (N.C. contact).
14-15: relay output 3 (N.O. contact).
15-16: relay output 3 (N.C. contact).
17-18: relay output 4 (N.O. contact).
18-19: relay output 4 (N.C. contact).
20: antenna braiding.
21: antenna.
ESP DEU POR
OUT4
6-1620020 rev.0 27/10/2015