Weee Notice - Klipsch SURROUND 3 Manual De Instrucciones

included power supply of the product. Operation from
other voltages other than those indicated may cause
irreversible damage to the product and void the products
warranty. The use of AC Plug Adapters is cautioned
because it can allow the product to be plugged into
voltages in which the product was not designed to
operate. If the product is equipped with a detachable
power cord, use only the type provided with your product
or by your local distributor and/or retailer. If you are
unsure of the correct operational voltage, please contact
your local distributor and/or retailer.
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European
Union Low Voltage Directive 2014/35/EU; European Union
EMC Directive 2014/30/EU; European Union Restriction of
Hazardous Substances Recast (RoHS2) Directive 2011/65/
EU; European Union WEEE Directive 2012/19/EU; European
Union Eco-Design Directive 2009/125/EC; European Union
Registration, Evaluation, Authorization and Restriction of
Chemicals (REACH) Directive 2006/121/EC; European Union
Radio Equipment Directive (RED) 2014/53/EU.
This product contains batteries that are covered under
the 2006/66/EC European Directive, which cannot be
disposed of with normal household waste. Please follow
local regulations.
You may obtain a free copy of the Declaration of
Conformity by contacting your dealer, distributor, or
Klipsch Group, Inc.'s worldwide headquarters. Contact
information can be found here: http://www.klipsch.
com/Contact-Us

WEEE NOTICE

Note: This mark applies only to countries
within the European Union (EU) and Norway.
This appliance is labeled in accordance with European
Directive 2012/19/EU concerning waste of electrical and
electronic equipment (WEEE). This label indicates that this
product should not be disposed of with household waste.
It should be deposited at an appropriate facility to enable
recovery and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) This device must accept any interference received,
including interference that may cause undesired operation.
NOTE: This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to part
15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause
harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a
particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be
determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Approved under the verification provision of FCC Part 15
as a Class B Digital Device.
Caution: Changes or modifications not expressly approved
by the manufacturer could void the user's authority to
operate this device.
Caution: To comply with the limits of the Class B digital
device, pursuant to Part 15 of the FCC Rules, this device
is to comply with Class B limits. All peripherals must be
shielded and grounded. Operation with non-certified
peripherals or non-shielded cables my result in
interference to radio or reception.
WIRELESS TRANSMITTER COMPLIANCE INFORMATION
Radiation Exposure Statement:
This equipment complies with FCC radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated
with minimum distance 20cm between the radiator
& your body.
Slave Equipment: (for play-fi module 2.4G and 5GHz
dual bands)
This device is slave equipment, the device is not radar
detection and not ad-hoc operation in the DFS band.
Industry Canada statement:
This device complies with Industry Canada's licence-
exempt RSSs. Operation is subject to the following
two conditions:
(1) This device may not cause interference; and
(2) This device must accept any interference, including
interference that may cause undesired operation
of the device.
Caution:(for play-fi module 2.4G and 5GHz dual bands)
(i) the device for operation in the band 5150-5250 MHz is
only for indoor use to reduce the potential for harmful
interference to co-channel mobile satellite systems;
(ii) the maximum antenna gain permitted for devices in
the bands 5250-5350 MHz and 5470-5725 MHz shall be
such that the equipment still complies with the e.i.r.p. limit;
(iii) the maximum antenna gain permitted for devices
in the band 5725-5850 MHz shall be such that the
equipment still complies with the e.i.r.p. limits specified
for point-to-point and non-point-to-point operation as
appropriate; and
(iv) the worst-case tilt angle(s) necessary to remain
compliant with the e.i.r.p. elevation mask requirement set
forth in Section 6.2.2(3) shall be clearly indicated.
(v) Users should also be advised that high-power radars
are allocated as primary users (i.e. priority users) of
the bands 5250-5350 MHz and 5650-5850 MHz and that
these radars could cause interference and/or damage
to LE-LAN devices.
Radiation Exposure Statement:
This equipment complies with ISED radiation exposure
limits set forth for an uncontrolled environment.
This equipment should be installed and operated
with minimum distance 20cm between the radiator
& your body.