Hog Slat GrowerSELECT HS765 Guia De Inicio Rapido

Grow-Flex™ Feed Systems
HS765
Multi-Hopper Switch Isolator - 240V
(Spanish Version Included/ Versión en Español Incluida)
General Installation Notes:
Make sure that power is disconnected from system prior to servicing.
Installation of this equipment and related OEM equipment should be in accordance with these instructions,
OEM's installation instructions and local codes (if applicable). Failure to follow specified instructions may cause
damage to equipment and/or personal injury or death.
Take special note of any Warnings or Safety Decals on the equipment and in manuals.
Always wear protective clothing and any applicable Personal Protective Equipment (Safety Glasses and/or Ear
Plugs) when working with the equipment.
Discarded materials, equipment and boxes should be recycled in accordance with local and national codes.
Note: Unit is to be wired in accordance with all applicable local and national electrical wiring codes. All wiring sizes and fuse capacities are to be sized
according to applicable electrical code specifications or other regulations.
Safety Instructions:
Read all safety messages in this manual and on equipment safety decals. Follow recommended precautions and
safe operating practices.
Ground all electrical equipment for safety.
Ground all non-current carrying metal parts to guard against electrical shock.
Always keep safety decals in good condition and replace missing or damaged decals.
Overview:
The HS765 Multi-Hopper Switch Isolator allows for the connection of up to four hopper level switches to one
location providing a single Normally Closed (N/C) output. The output can be connected to an Auger Drive Control
Unit such as Grower Select HS693 or any control unit containing an isolation relay to control the operation of the
auger motor. The four hopper level switches are isolated so that electromechanical or two wire proximity
switches can be used in any combination. With the HS765, any of the four switches can call for feed causing the
auger motor to power on.
Electrical Specifications:
Relay Output Contact Rating: 1 ½ HP @ 220-240VAC 50/60 Hz
Hog Slat Inc. Newton Grove, NC USA December 2018
1