NSS Enterprises CHARGER 2717 DB Instrucciones Originales página 11

 Place one end of the gas spring against a hard
surface and push on it. If you can compress it, it
must be replaced. If you can not compress it, it is
most likely OK.
Pad Pressure Adjustment
The NSS Charger 2717 DB and Charger 2022 DB
is preset at the factory for medium duty
applications. It can be tuned to your specific
application for optimum performance.
ONLY an authorized NSS Service Station should
perform this adjustment.
Tools required for Pad pressure adjustment
1) ¾ open end wrench
2) Clamp on Amp Meter
 It is necessary to use a clamp on AMP Meter when
adjusting the pad pressure.
 There are many different manufactures and
models of AMP Meters to choose from. Two AMP
Meters are shown above. The one on the left is
AMPROBE Model ACDC-610 and the one on the
left is AMPROBE Model ACDC-400.
Checking the Pad Motor Amperage
 First install a new pad on the pad driver. Caution:
Checking the Amps with a used pad will cause the
machine to have high amps when a new pad is
installed.
 Lower the Pad Motor into the operating position
and open the cover over the battery compartment.
 Put the clamp on AMP Meter around the red
(positive) wire coming from the battery pack to the
machine as shown.
 While running the machine read the amp meter.
The amp meter should be reading between 70-80
amps for the Charger 2717 DB & 50-70 amps for
the Charger 2022 DB.
Pad Pressure Adjustment
If adjustment is required, follow these
instructions.
 It will be easier to access the lock nut and spring
guide rod assembly with the machine in the pad
change position.
 First loosen the lock nut on the spring guide. With
the lock nut loose, the spring guide rod assembly
will be easily turned by grasping the set collar on
the spring guide rod.
 Turn the spring rod guide assembly ½ to 1 turn at a
time. A little adjustment goes a long way.