Configuration; Technical Data - Bosch FNM-420V-A-WH Manual Del Usuario

en | Notices
12
3.
4.
5.
6.
3

Configuration

You can customize and program the voice messages and signals
using the FNM-420V Configuration Software.
The software can be downloaded from the online catalogue at
www.boschsecurity.com.
System requirements: Windows 7.
The FNM-420V Software Configuration Guide describing the
software and the programming of the sounders in detail is also
available for download at www.boschsecurity.com.
4

Technical data

Operating voltage
Current consumption
–
–
Max. power consumption
Connections
2015.11 | 4.0 | F.01U.273.478
Fit the rear of the housing on a level, dry surface using the
pre-punched and/or any existing bore holes (3) and a
minimum of two screws.
Wire up the sounder using the terminal block.
For uninterruptible alarm signalling insert the battery into
the battery holder (4) and connect the battery. Push the
loose battery plug into the specified bushing (5) as far as it
will go.
Close the housing by clicking the sounder into place in the
snap-fit hooks or fastening the sounder in place with the
four screws (6).
Standby
Alarm
Voice Sounder Indoor
FNM-420V-A-RD /
FNM-420V-A-WH
15 - 33 V DC
< 2.3 mA
≤ 15 mA
0.495 W
0.6 mm to 2.5 mm
2
Bosch Sicherheitssysteme GmbH
2