Kenmore 116.39110 Manual De Uso Y Cuidado página 20

Alwaysfollow all safety precautionswhen
performing maintenance to the vacuum
cleaner
WARNING
Electrical Shock Or Personal Injury
Hazard
Disconnect electrical supply before
performing maintenance to the
vacuum cleaner, Failure to do so
could result in electrical shock or
personal injury from the vacuum
cleaner suddenly starting,
If the vacuum cleaner does not seem to
have adequate suction, first check if the dust
bag is full or if a filter is clogged See DUST
BAG REPLACEMENT section.
If the dust bag and filter areas are free of
clogs, check the extension hose,
TO REMOVE CLOG FROM
HOSE
1, Rotate the extension hose release lever
counter-clockwise to release extension
hose°
Extension
Hos_
Wand
Wand
Extension Hose
Release
Nozzle
Hose
2. Remove the lower end of the extension
hose from the wand holder by grasping the
hose collar, twisting, and pulling straight up
3, Plug in the vacuum cleaner and turn it on
4, Stretch the extension hose to maximum
length and then allow the hose to return to
its natural length.
_' " _;":_' _ Original
, ' -. Hose
Storage
Position
Hose
5. Re-insert the hose into the original
storage position from which it was removed°
Press firmly to assure connection
6. Rotate hose release lever clockwise to
the locked position.
WARNING
Personal Injury Hazard
DO NOT place hands or feet under-
neath the vacuum cleaner at any
time,
If the dust bag, filter areas and the hose
areas are free of clogs, disconnect the
nozzle hose from the wand holder and
check the nozzle for clogging.
Clean the agitator according to the
instructions in the AGITATOR CLEANING
section.
Return the vacuum cleaner to the upright
position before plugging into an electrical
outlet.
2O