Jam TWS ANC Folleto De Instrucciones página 4

Bluetooth ®
Devices
JAM TWS ANC
STEP 3 – CONNECTING TO A DEVICE
on your device. From the Bluetooth
Enable Bluetooth ®
menu, select "JAM TWS ANC". When the device and
TWS ANC are connected, you will hear a tone and the
LEDs on the earbuds will slow flash blue. This means
the pairing is complete.
To disconnect from all connected devices and reset
pairing, remove both earbuds from the charging case
to power them on (or power them on manually). Then,
tap the touch sensor on either earbud quickly 5 times.
You will hear the pairing tone and the LEDs on the left
earbud will flash red and blue. This means they are
disconnected and ready to pair to a Bluetooth device.
CONNECT 1 EARBUD
Use the left or the right earbud independently. This is
a great option if you want to hear your surroundings
as well as your music.
STEP 1 – TURNING ON THE EARBUD
Your earbud will automatically turn on when taken out
of the portable charging case. If you need to turn it on
manually, you can press and hold the touch sensor for
4 seconds on the earbud.
EN
or
long-press 4s
STEP 4 – USING ANC
When the JAM TWS ANC Earbuds are powered on,
the ANC is turned off. To turn on the ANC, tap the
touch sensor on the right earbud three times. You will
hear a single tone; which means the ANC is activated.
To turn off the ANC, tap the touch sensor on the right
earbud three times again. You will hear two tones
which means the ANC is deactivated.
NOTE: The ANC feature cannot be utilized when only
using one earbud.
L
STEP 2 – PAIRING MODE
Once a single earbud is taken out of the case or
manually turned on, it should enter into pairing mode.
The LED will flash red and blue and you will hear
a series of tones. This will indicate your earbud is
in pairing mode. If it does not enter pairing mode
automatically, place the earbud back in the charging
case for 2 seconds and then remove it again to enter
pairing mode.
tap 3x
R
4