Multiple Timers; Hot Light Indicator; Pan Detection Removal - Monogram ZHU30 Manual Del Propietário

USING YOUR COOKTOP

MULTIPLE TIMERS

Timer Mode
For more information see Custom Settings, Timer Mode
section for Multi-Timer feature. Each burner can be linked to
a timer. Burner must be on to set the timer. When more than
one burner is on, the order of the timer is from left to right.
To Turn ON Multiple Timers
1. Touch the Timer Select pad. The corresponding burner
power level and the display will blink. Touch the
arrows to adjust time. Timer automatically starts after 3
seconds if there is no further action. The "ON" LED will
light when timer is on.
2. To set timer for the next burner, touch the Timer Select
pad. The corresponding burner power level and the
display will blink. Touch the
time. Timer automatically starts after 3 seconds if there
is no further action. The "ON" LED will light when timer
is on. Repeat the steps for the remaining timers.
To Turn ON Multiple Timers
Hold Timer Select pad for 3 seconds to cancel timer. The
corresponding burner power level and display will blink.
When the burner times out, the corresponding timer also
times out.

HOT LIGHT INDICATOR

A hot surface indicator light (one for each cooking element)
will glow when the glass surface is hot and will remain on
until the surface has cooled to a temperature that is safe to
touch.

PAN DETECTION REMOVAL

When a pan is removed from the cooktop surface, Burner
level turns off; Power arc starts to blink. If a pan is not
detected for 25 seconds, the control turns off automatically,
lights turn off.
49-80826 Rev. 4
or V
or V arrows to adjust
Burner Power Level
Hot Surface Indicator Light
Display
Power Arc
11