Honeywell HEV320 Serie Manual De Instrucciones página 4

PREPARE WICKING FILTER
Step 1
1. Lift Motor Housing.
2. Run Wicking Filter under cool water until saturated.
3. Gently place wet Filter in Base; do not squeeze out excess water.
FILLING/REFILLING WATER TANK
Step 1
1. Remove the Water Tank and carry to sink or tub. Turn Tank upside down and remove the
Tank Cap by turning counter-clockwise (left). You can grasp the outside of the Tank Cap or
the inside support ribs, whichever is more comfortable for you.
2. Fill the Water Tank with cool tap water. Do not use warm or hot water. The Tank and
Reservoir combined hold approximately 0.8 gallons (3.0L) of water.
NOTE: The top of the Water Tank is flat so it should sit flat in your sink. If it does not fit, the
large Tank opening will allow you to tip the Tank sideways to fill.
3. Replace Tank Cap and secure tightly by turning clockwise (to right).
4. Carry full Water Tank back to humidifier using two hands; one hand on Tank Handle at the
top of the Tank and other hand supporting the bottom of the Tank. Take care not to push the
plunger on the bottom of the Water Tank or leaking may occur.
5. Place the Water Tank on the humidifier Base. You will hear the water draining
into the Reservoir.
4
Step 2
Step 2
Step 3
Step 3

Step 4 Step 5
