Cequent Performance Products 65049 Instrucciones De Instalación

Truck cab mount Bumper
Truck frame
Receiver Shown In Proper Position
Equipment Required:
Fastener Kit: 65049F
Wrenches: 13/16", 7/8",
15/16" ,18mm
Drill Bits: None
4 3 2 1
Remove existing brackets if present
both sides. Return to owner.
This is a magnified
view of a Bolt Leader
Qty. (2) Hex Bolt, 9/16"-12 x 2" Gr5
1
Qty. (2) Flat Washer, 9/16"
2
Qty. (2) Lock Washer, 9/16"
3
Qty. (2) Hex Nut, 9/16"
4
1. On newer model trucks it is necessary to trim or cut opening in plastic air dam attached to bottom of bumper.
2. It may also be necessary to remove existing frame end brackets if present. See above.
3. Position hitch and install fasteners as shown above. Using 5/8" bolt leader to pull 5/8" carriage bolt into frame slot.
4. Torque fasteners to specifications below.
CONSULT VEHICLE OWNER BEFORE TRIMMING OR CUTTING PLASTIC AIR DAM.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body
panels to prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety
precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C.
Regulation V-5 and SAE J684.
2007, 2009 Cequent Performance Products
z
Front Mounted Receiver
Installation Instructions
Ford SuperDuty 250/350/450
All including Cab-on-Chassis
Air dam Ai d
7 6 8 5
4
On newer models with bracket on outside of
frame insert this bolt from opposite direction
Tighten all 9/16" GR5 fasteners with torque wrench to 110 Lb.-Ft (149 N-M).
Tighten all 5/8" GR5 fasteners with torque wrench to 150 Lb.-Ft (203 N-M).
CARGO CAPACITY – Do not exceed
Gross Axle Weight Rating, (GAWR).
Forward truck
9,000lb.
frame
Truck frame cut-away to
show Bolt Leader through
slot in truck frame slot in truck frame
Rear tab of hitch aligns with slot
in frame between mount bracket
3 2 1
Bolt Leader shown Bolt Leader sho n
7 6 8 5
Qty. (2)
5
Qty. (2)
6
Qty. (2)
7
Qty. (1)
8
Sheet 1 of 3
Part Numbers:
500 LB. or Truck Front
MAXIMUM WINCH LINE PULL
Mount bracket cut-away
to show detail
On some models be careful
not to pinch electrical wiring
between hitch and bumper.
Carriage Bolt, 5/8"-11 X 2" Gr5
Lock Washer, 5/8"
Hex Nut, 5/8"
Bolt Leader, 5/8"
65049N 10-12-09
65049
Forward truck cab
mount bracket
End of Bolt Leader
i h l i l i i
Rev. C