Cequent Performance Products 65056 Instrucciones De Instalación

Hitch Shown In Proper Position
Equipment Required: Utility Knife, E i t R i d Utilit K if
Tape Measure & Marking Pencil.
Fastener Kit: 65056F
Wrenches: 3/4" & (2) 18mm
Drill Bits: None
3 3
4
Tow hooks and
fascia not shown.
1
Qty. (2) Hex bolt 1/2-13 X 1.500 GR5
2
Qty. (2) Flat washer
Trim fascia for receiver tube.
1. Trim fascia. See fascia trimming information for proper vehicle model:
Note: CONSULT VEHICLE OWNER BEFORE TRIMMING.
2. Remove the flange nuts on the 2 bolts (1 each side) from existing tow hooks. On driver's side loosen bolt until flush with the
inboard frame rail. On passenger's side remove bolt. Keep for re-installation.
3. Raise hitch into position and push both bolts through brackets to support the hitch.
Note: If there is interference with the bumper support, loosen (do NOT remove) and lift the bumper upward for extra clearance.
4. Insert ½-13 hex bolt and flat washer thru access hole on inside frame rail and thru hole in frame and slot in hitch side bracket,
both sides.
5. Secure with conical toothed washers and hex nuts..
6. Tighten all fasteners to the required torque specification.
7. If bumper support was loosened in Step 3 re-tighten.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2010 Cequent Performance Products
Installation Instructions
Chevrolet Silverado 2500 HD, 3500 HD
GMC Sierra 2500 HD, 3500 HD
Does not fit Denali HD due to extensive fascia cutting
Note: Fascia trim required. Obtain vehicle owners approval before cutting
Fascia
NOTE: If front mounted license
plate is present, repositioning
may be necessary.
Access Hole
2 2
1
p g
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Tighten all M12 CL10.9 fasteners with torque wrench to 92 Lb.-Ft. (125 N*M)
9,000 lb.
(4086 Kg)
Flange nuts for existing
tow hooks
Fascia trim required. Obtain vehicle owners approval before cutting
3
Qty. (2) Conical Toothed Washer
4
Qty. (2) Hex Nut ½-13
p
Sheet 1 of 6 65056N
Part Numbers:
CARGO CAPACITY – Do not exceed
500 LB. (227 Kg) or Truck Front
Gross Axle Weight Rating, (GAWR).
MAXIMUM WINCH LINE PULL
MAXIMUM WINCH LINE PULL
Crossmember shown
Cut off for clarity
Bumper support
Existing M12 Flange Bolt -
Typ
Note: Fasteners typical
both sides
9-2-10
Form: F205 Rev A 5-6-05
65056
Rev. A