Installing/Removing The Belt Clip; Installing The Belt Clip; Removing The Belt Clip; Connecting The Earphones - Silvercrest SFG 8000 B2 Manual Del Usuario E Instrucciones De Seguridad

The handheld transceivers cannot be used while they are charging.

9.3. Installing/removing the belt clip

9.3.1. Installing the belt clip

Insert the belt clip into the guide located at the handheld transceiver
back panel. The belt clip must click into place.

9.3.2. Removing the belt clip

To remove the belt clip from the handheld transceiver, use your
finger to release the belt clip lock (see the arrow). Once unlocked,
slide the belt clip upwards out of the guide.

9.4. Connecting the earphones

You can use your handheld transceivers with suitable earphones (not supplied). The earphones receptacle
[3] is located behind a protective cover.
Before connecting the earphones, you must reduce the sound volume (see page 18), otherwise you risk
damaging your hearing due to the high earphones level.
1. To connect the earphones, open the rubber cover that protects the earphones receptacle [3].
2. Insert a 2.5 mm jack-type earphones plug into the earphones receptacle [3].
Risks associated with high noise levels
When using the earphones, the IPX2 protection against vertically falling
drops of water with tilted enclosure is not guaranteed.
SilverCrest SFG 8000 B2
(The figure is representational)
English - 17