Searching For An Active Channel; Searching For A Ctcss Code; Searching For A Dcs Code - Silvercrest SFG 8000 B2 Manual Del Usuario E Instrucciones De Seguridad

SilverCrest SFG 8000 B2

11.4.1. Searching for an active channel

 Press the Menu
 Press the Up  [10] or Down  [7] button to launch the channel search.
The scan will stop automatically once an active channel has been found. Then you can listen to the
transmissions. Once the transmission on the active channel is terminated, the channel search continues.
Pressing the PTT button [12] while listening to a found channel, the handheld transceiver
will use that channel and return to idle mode.

11.4.2. Searching for a CTCSS code

If an active channel is found, press the PTT button [12] to use the found channel. Next you can search for
the CTCSS or DCS code being used.
 Press the Menu
 Press the Up  [10] or Down  [7] button to scan the selected channel.
Once a transmission is detected on the selected channel, its CTCSS code (if any) is detected and
displayed.
Pressing the PTT button [12] will cause the handheld transceiver to use that code and
return to idle mode.

11.4.3. Searching for a DCS code

 Press the Menu
 Press the Up  [10] or Down  [7] button to scan the selected channel.
Once a transmission is detected on the selected channel, its DCS code (if any) is detected and displayed.
Pressing the PTT button [12] will cause the handheld transceiver to use that code and
return to idle mode.
22 - English
button [6] five times. The indication "SC" and the current
channel number will flash on the display.
button [6] six times. The indications "SC" and "CTCSS 00"
will flash on the display. The current channel number will also be displayed.
button [6] seven times. The indications "SC" and "DCS
00" will flash on the display. The current channel number will also be
displayed.