ASROCK Z87M Extreme4 Manual Del Usuario página 27

Power LED Header
(3-pin PLED1)
(see p.1, No. 18)
Serial ATA3 Connectors
(SATA3_0_1:
see p.1, No. 8)
(SATA3_2_3:
see p.1, No. 9)
(SATA3_4_5:
see p.1, No. 10)
USB 2.0 Headers
(9-pin USB4_5)
(see p.1, No. 17)
(9-pin USB6_7)
(see p.1, No. 18)
USB 3.0 Headers
(19-pin USB3_4_5)
(see p.1, No. 7)
1
PLED-
PLED+
PLED+
USB_PWR
P-
P+
GND
DUMMY
1
GND
P+
P-
USB_PWR
Vbus Vbus
Vbus IntA_PB_SSRX-
IntA_PB_SSRX+
IntA_PA_SSRX-
IntA_PA_SSRX+ GND
GND IntA_PB_SSTX-
IntA_PA_SSTX-
IntA_PB_SSTX+
IntA_PA_SSTX+
GND
GND IntA_PB_D-
IntA_PA_D- IntA_PB_D+
IntA_PA_D+ Dummy
1
Z87M Extreme4
Please connect the chassis
power LED to this header
to indicate the system's
power status.
These six SATA3
connectors support SATA
data cables for internal
storage devices with up
to 6.0 Gb/s data transfer
rate. If the eSATA port
on the rear I/O has been
connected, the internal
SATA3_1 will not
function.
Besides two USB 2.0 ports
on the I/O panel, there
are three headers on this
motherboard. Each USB
2.0 header can support
two ports.
Besides four USB 3.0 ports
on the I/O panel, there
are one header on this
motherboard. Each USB
3.0 header can support
two ports.
25