Tabla de contenido
Publicidad
8.52. Release Command
This page describes the syntax and how to use the command
To use this command, type
Description
Release
With the command
release values
Enter
for attributes in the programmer by a given object list. This list is filtered by the current
selection.
Important:
Release values that are stored with the option "Merge" release previously tracked values in the tracking
list and the fixtures use their default values.
Important:
-If you release an object, the command
-If you release an effect, the command
Syntax
release values
1. To enter
type into the command line:
Release Selection
R
The letter
will be subsequently displayed in the value layer.
release values
2. To enter
into the command line:
Release PresetType "position"
3. To enter release values for an effect in the programmer, number 4 for instance, type into the command line:
Release Effect 4
8.53. Comando Remove
© 2017 MA Lighting Technology GmbH | Dachdeckerstr. 16 | D-97297 Waldbüttelbrunn | Germany
Phone +49 5251 688865-27 | support (at)ma-dot2.com | www.malighting.com
d o t 2 U s e r Ma n u a l
Version 1.3
Release
into the
command
it is possible to:
Release
Release
for all attributes in the programmer within the selection of fixtures in the value layer,
for attributes of pan and tilt in the programmer within the selection of fixtures, type
Release
.
line.
will be applied to the value layer.
will be applied to the effect layer.
455
Publicidad
Tabla de contenido
