Campbell Hausfeld FP2095 Guia De Inicio Rapido

Setup Like a Pro
1
Close pressure regulator,
Turn on compressor and
Allow tank to reach
maximum pressure.
2 3
Attach air hose
to regulator outlet.
Adjust regulator
knob so outlet
pressure is between
60 psi and 100 psi.
Use 90 psi to
100 psi for
nailing or
stapling.
4
Pull back collar on
coupler. Insert nailer plug
or plug with attached inflation
accessory.
When using the Nailer / Stapler,
Place 4 to 5 drops of nailer
Tip
oil in air inlet. nailer back
to reduce spillage.
ON / OFF Switch
IMPORTANT: Drain tank after
each use. After tank is drained,
tighten drain knob. Make sure
drain is completely shut / closed
to help eliminate air leaks.
2 Inch 2-in-1 Brad Nailer / Stapler
Part Number: SB504000XX
- or -
1-1/4 Inch 2-in-1 Brad Nailer / Stapler
Part Number: XX323200AV
Nailer Oil Crown Staples (Qty: 100)
Part Number: ST127012AV Part Number: FN258K00AV
FP2095 — Oilless Compressor
Compressor
Pressure Regulator Knob
Regulator Outlet
Male Plug
Male Plug
Female Coupler
Recoil Air Hose
2 Inch Brad Nails (Qty: 1000) Tire Chuck, (2) Inflation
Part Number: FB180050AV Nozzles, Inflation Needle,
- or - and Inflation Adapter
1-1/4 Inch Brad Nails (Qty: 1000) Part Number: FP204008AV
Part Number: FB180030AV
3mm Allen Wrench 4mm Allen Wrench Female Coupler
Part Number: SV109300AV Part Number: SV109400AV Part Number: MP288300AV
Use a wrench to
tighten threads when
connecting hose,
coupler, and plug. Inflation Nozzle
Adapter
Inflation Nozzle
Inflation Needle
Tire Chuck
OIL: For
use with
Brad Nailer /
Stapler.
Brad Nailer / Stapler
Recoil Air Hose
Part Number: MP268100AV
Male Plug
Part Number: MP246800AV