Dmx Linking - Colorist POD 1Qa Guía De Referencia Rápida

Colorist Pod 1Qa QRG

DMX Linking

DMX Connection
IP65 DMX Cable
Table
IP65 DMX
Connector Pins
RDM
(Remote Device
Management)
Ilumicode
Control Panel
Description
The Colorist Pod 1Qa will work with a DMX controller using a regular
DMX serial connection.
www.iluminarc.com.
The Colorist Pod 1Qa uses a regular DMX data connection for its DMX
personalities: 1ch, 4ch, 5ch, 6ch, 7ch, and 10ch. See the User Manual to
connect and configure for DMX operation.
Connection
Ground
Data -
Data +
Male IP65 (DMX Input)
To connnect the Colorist Pod 1Qa to your DMX network, it is
necessary to use the 3-pin IP65 to 5-pin adapters supplied with this
product.
When not using the Power Output, DMX Input or DMX Output
connectors, you must seal the cable ends with the supplied caps.
Remote Device Management, or RDM, is a standard for allowing DMX-
enabled devices to communicate bi-directionally along existing DMX
cabling. Check the DMX controller's User Manual or with the
manufacturer as not all DMX controllers have this capability. The
Colorist Pod 1Qa supports RDM protocol that allows feedback to make
changes to some menu map options. Download the User Manual from
www.chauvetprofessional.com
Button
<MENU> Exits from the current menu or function
Enables the currently displayed menu or sets the currently
<ENTER>
selected value into the selected function
Navigates upwards through the menu list and increases the
<UP>
numeric value when in a function
Navigates downwards through the menu list and decreases
<DOWN>
the numeric value when in a function
A DMX Primer
DMX (U.S.) DMX (Europe)
Shield
White
Red
F
emale IP65 (DMX Output)
for more details.
Function
4
is available
IP65 Pin
Shield
Blue
Brown
EN
from
1
2
3