Cequent Performance Products 45502 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
Rear
NOTE: THIS PRODUCT IS NOT RECOMMENDED
FOR USE ON A 1/2 TON VEHICLE.
1. Place the hitch up to the frame with the large hole in the hitch flange over the rivet head near the end of the frame. Clamp the hitch in place.
2. Using the holes in the brackets as a guide, drill eight 1/2" holes into the truck frame.
3. Insert a 1/2" carriage bolt with the small bolt plate and the two hole plate through the rear hole in the frame. Install 1/2" serrated washers, lock washers and nuts on the bolts.
See the diagram on the other side.
4. Insert 1/2" carriage bolts with the large bolt plates down into the remaining holes. Install 1/2" serrated washers, lock washers and nuts on the bolts.
5. Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
NOTE: To use the adapter bushing with some 2" weight distributing bars, it will be necessary to sand the corners of the bar to get it into the bushing.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2016 Cequent™ Performance Products, Inc. -
Installation Instructions
PART NUMBERS: 45502, 45702, CQT45502
Note: Fasteners typical
Figure 1
Printed in Mexico
both sides
①
②
①
⑥
⑦
③
④
⑤
Sheet 3 of 9
Fastener Kit : 45502F
① Qty. (8) Carriage bolt
½-13 x 2.00 GR5
② Qty. (6) Spacer
.250 x 1.5 x 3
③ Qty. (8) Conical Washer
½''
④ Qty. (8) Lock washer
½"
⑤ Qty. (8) Hex Nut
½ -13 GR5
⑥ Qty. (2) Spacer
.250 x .9 x1.4
⑦ Qty. (2) Spacer
.25 x 1.43 x 2.32
Conical washer
Teeth side
against hitch
45502N 6-3-16 Rev. A