Cequent Performance Products 75225 Instrucciones De Instalación página 3

Always wear SAFETY GLASSES
when installing hitch
Frame rail
Weldnut
Teeth side
against hitch
Scan for step by step
PHOTO installation
instruction or visit
http://www.cequentgro
up.com/qr-product.aspx
1. Spare tire lower down – open the trunk and use the tools under storage compartment to lower down the spare tire, see Figure 2.
2. Hitch installation – raise the hitch into position and loosely install M14 bolt ① and conical washer ② into weldnut, see Figure 3.
3. Tighten all M14 CL10.9 fasteners with torque wrench to 148 Lb.-Ft. (201 N*M)
Proper torque is needed to keep the hitch secure to the vehicle when towing.
4. Raise the spare tire back into position. Make sure the spare tire won't interfere with hitch.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A hitch or
ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684.
©2015 Cequent™ Performance Products, Inc. - Printed in Mexico
Installation Instructions
PART NUMBERS: 75225, 87691, 44778
Fastener Kit: 75225F
Figure 1
Rear
Spare tire
Sheet 3 of 12
① Qty. (6)
② Qty. (6)
Figure 2
Figure 3
②
NOTE:
Fasteners
Hitch does not fit with
①
typical
full size spare tire
both sides
75225NP 07-15-15
Bolt M14
1.50 x 45, CL10.9
Conical washer
5/8''
Rev. A