Publicidad
Idiomas disponibles
Idiomas disponibles
Enlaces rápidos
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 75471F
Wrenches: 16mm
Drill Bits: None
1
Qty. (4)
M10 X 1.25 X 30mm CL10.9
2
Qty. (4)
7/16 Lockwasher
1.
Raise hitch into position.
2.
Install M10 X 1.25 bolts 7/16 lockwasher and 3/16 X 1.00 X 2.00 Blocks into existing weldnuts inside vehicle frame rails.
Tighten all M10 X 1.25 CL10.9 fasteners with torque wrench to 59 Lb.-Ft. (80 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
z
2006, 2007, 2008. 2011 Cequent Performance Products
Installation Instructions
Hyundai Santa Fe
Fascia
Weight Distributing
Wiring Access Location: SUV3, SUV4
Frame Rail
Exhaust
3
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Max Gross
Hitch type
Trailer WT (LB)
Not For Use With Spring Bars
Weight Carrying
3500 (1589 Kg)
Ball Mount
Existing
Existing
weldnuts
Qty. (4)
3/16 X 1.00 X 2.00 Block
75471N
Part Numbers:
75471
44549
87414
75221 UHAUL
75221 UHAUL
Max Tongue
WT (LB)
525 (238 Kg)
5-1-11
Rev. E
Publicidad
Manuales relacionados para Cequent Performance Products 75471
Resumen de contenidos para Cequent Performance Products 75471
- Página 1 This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. Sheet 1 of 3 75471N 5-1-11 Rev. E 2006, 2007, 2008. 2011 Cequent Performance Products...
- Página 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. Feuille 2 de 3 75471N 5-1-11 Rev. E 2006, 2007, 2008. 2011 Cequent Performance Products...
- Página 3 Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684 Hoja 3 de 3 75471N 5-1-11 Rev. E 2006, 2007, 2008. 2011 Cequent Performance Products...