Atlantic L-305 Manual De Producto página 2

Introduction
Thank you for choosing this Atlantic TidalWave L-Series pump. Before using this pump
please take a moment to review this manual.
To avoid an accident do not use the pump in any way other than as described in this
manual. Please note the manufacturer cannot be responsible for accidents arising because
the product was not used as prescribed. After reading this manual keep it as a reference in
case questions arise during use. Using the pump in a manner that is not prescribed will void
the warranty.
MODEL MAX FLOW
L-305 11400
L-310 14200
Recommended Operating Range
Prior to Operation and Installation
When the pump is delivered, first perform the following checks:
• Check for any damage to pump and power cable that may have occurred during
the shipment.
• Check the model number to make sure it is the product that was ordered and verify the
voltage and frequency are correct.
Caution
• DO NOT operate this product under any condition other than those for which it is specified.
Failure to observe this precaution can lead to electrical shock, electrical leakage, fire, water
leakage or other problems.
• L-305/L-310 pumps require a single phase 115 volt / 60 hz power supply. Always verify that
the supplied power meets the requirements listed on the upper pump cover.
• DO NOT apply any paint over the stainless steel motor body. Reduced cooling ability will
result in overheat, overload, introduce undesirable performance reductions, periodic auto
shut-off and pump malfunction.
• Never place your hand or any object in or near the inlet opening while this equipment
is operating. If pump inlet is clogged, always turn off the power supply, fuse box or circuit
breaker and wait until the motor is completely stopped before attempting to remove any
clogged material.
• Please make sure that the power plug and the AC outlet receptacle is protected and away
from water or pump discharge hose to prevent accidental electric shock or short circuit.
• Always operate the pump completely submerged in water.
• Avoid dry operation, which will not only lower performance but can cause the pump to
overheat/malfunction, leading to electrical leakage, shock or premature failure.
• CAUTION:
THIS PUMP IS TO BE USED IN A CIRCUIT PROTECTED BY A GROUND CIRCUIT INTERRUPTER.
• ATTENTION:
CETTE POMPE DOIT ETRE BRANCHEE A UNE DERIVATION PROTEGEE PAR UN
DISJONCTEUR DIFFERENTIEL.
• CAUTION:
THIS PUMP HAS BEEN EVALUATED FOR USE IN WATER ONLY.
2
5' 10'
10380 7380
13500 10560
Best Efficiency Range
15' 20'
3960
7380 3240
Do Not Operate Range
25' 30'