Mestra R-100210 Manual De Instrucciones página 6

The R-100210 distiller/decalcifier is a simple and practical appliance: you will obtain 4 litres of distilled
water by just filling the tank with tap water and waiting for about 6 hours. Its operation is fully automatic
and silent. Cleaning the tank is easy and quick. The water produced is very pure (between 2 and 10
mg/litre of solid residue) and can be used in a large number of applications in the clinic and the dental
lab (autoclaves, compound making, steam generating machines, etc.).
IMPORTANT- The appliance produces water of the "DISTILLED" type. It cannot be used in
injections, vials, and wound cleaning or in any other surgical operation that requires "TRI-
DISTILLED" type water.
SAFETY
- Read these instructions carefully before operating the unit.
- Keep these instructions for further consultation.
- Install the distiller on a dry, stable, heat-resistant and well-ventilated surface.
- The distiller requires a well-ventilated room. Bear in mind that while operating it emits heat.
- Use the unit exclusively for the aim it was designed.
- Do not allow children or non-qualified personnel handling the unit.
- Keep the citric acid container out of children's reach.
- Disconnect the unit from the power source for maintenance operations.
- Unplug the distiller for cleaning or refilling it.
- Do not dip any element of the distiller.
- If you need to interrupt the distillation cycle, stop the distiller by unplugging it.
- Do not open the distiller while it is working.
- Wait at least 20 minutes after a distillation cycle to open the distiller for cleaning it.
- Do not fill the tank with boiling water.
- WARNING: to prevent electric shock hazards, connect the unit to a proper power source
(grounded 230 V, 50/60 Hz).
- Do not use cord extensions or connect any other appliance into the same outlet.
- Do not use the unit in damp rooms or near inflammable materials (alcohol, solvents...)
OPERATION
1. Put an activated carbon packet (L) in the nozzle. Rinse and clean it under the tap (Fig 1).
Note: fold the filter by half to place it in the cap.
2. Put the nozzle in its place (Fig 1).
3. Open the lid (E). Note: to do this, do not pull the handle.
4. Pour water in the tank making sure not to exceed the mark. It is about 5 cm from the top.
UNSUITABLE WATER FOR SURGICAL USE!
EN
English