Cleaning And Care; Trouble Shooting - Infiniton SD-3M El Manual Del Propietario

MAINTENANCES

Cleaning And Care

Filter clean
• Clean the lint filter after each use.
Remove by pulling straight up.
• Cleaning filter
Use wiping cloth or your fingers.
• Install filter
If the filter is cleaned by damp cloth
or water, please install after
the sun dry.
Cleaning cabinet and inner tube
• Use soft damp cloth wipe when
cleaning cabinet and inner tube.
• Not to rinse by water direct.
• Not to use neutral scour wipe.
• Not to use gasolene and alcohol wipe.
• Make sure open the front door for aeration after
cleaning the inner tube.
g a s
thin ner
alcohol
13
MAINTENANCES

Trouble Shooting

Trouble Cause
Power cut.
The power plug is not
plugged tight.
Will not start
Dry clothes exceed.
The temperature fuse is cut.
The lint filter is dirty.
External hot or
The uptake or exhaust duct
can smell hot
is dirty.
The clothes in machine are
too full.
Not to take out the clothes
in time when finish.
Clothes too dry
The clothes don't assort
properly.
The temperature is enacted
too high.
Too dry.
Clothes shrink
It is right for synthetic fibre
and permanent press fibre
Hairball on
clothes
causing hairballs.This is
because the right rub causing.
Solution
Wait for switching on electricity.
Check the power socket,make sure plug tight.
The clothes in dryer must be after spinning,
and drying clothes can not exceed 3kg.
Please career man restore the temperature fuse.
Make sure clean the lint filter in time.
Clean out the stem.
.
Make sure the clothes are not too full
Take out the clothes immediately when finish.
Observe the maintenance label on clothes.
Observe the maintenance label on clothes.
if easy to shrink,should examine the clothes
when dry.Take out the clothes when tiny damp
for too dry.Then hang the clothes until full dry.
,
Use fabric softener lubricate fibre please spray
settled gule on cuff and neckline when iron
clothes . Turn the sarcenet out for reducing
.
rub
14