Publicidad
Idiomas disponibles
Idiomas disponibles
Purpose and function
This product is part of an Mitel communication
solution. In GAP mode the device can also be op-
erated on systems by other manufacturers, pro-
viding they support the GAP standard. Any other
use does not comply with the intended purpose
and is not permitted.
The individual products and components are co-
ordinated and must not be used for other purpos-
es or replaced by third-party products or compo-
nents (unless it is to connect other approved net-
works, applications and terminals to the interfac-
es provided specially for that purpose).
Dealing with batteries
Please observe the following rules and regula-
tions when dealing with batteries.
General rules when dealing with batteries
• Never tamper with or dismantle batteries.
• Never immerse the batteries in water or throw it
into a fire.
• Do not expose the batteries to high tempera-
tures.
When putting your cordless phone into opera-
tion
• Only use the battery pack supplied by the man-
ufacturer.
• Observe the instructions in the "Installation"
chapter and follow the procedure described
there.
• It takes two to three charging cycles for the bat-
teries to reach their fully charged state.
• Only use the charging unit supplied by the
manufacturer.
• For the charging unit only use the plug-in pow-
er adapter supplied by the manufacturer
(ID: 23-001061-00 or 23-001089-00). Otherwise
the phone may be damaged.
When operating your cordless phone
• It is normal for the batteries to become warm
when charging.
• Discharge the batteries from time to time to
prolong their service life. Do not place the cor-
responding cordless phone back into the charg-
ing unit until the batteries are not fully or al-
most fully discharged.
To replace the batteries
• Switch off the cordless phone before removing
the batteries.
• Only use original batteries and charging units
approved by the manufacturer. To do so, con-
tact your supplier or servicing agent.
To store the cordless phone or the batteries
• If you do not intend to use the phone for some
time, switch off the phone and take out the bat-
tery pack.
• Store the batteries at room temperature.
Above-average temperatures tend to reduce
the service life of batteries.
To dispose of the battery packs
Do not throw away the batteries with your do-
mestic waste. Take the batteries to an appropriate
collection point for recycling.
Exclusion of liability
This product was manufactured in accordance
with ISO 9001 quality guidelines.
This product and the user information belonging
to it have been produced with the utmost care.
The product's functions have been tested and ap-
proved after comprehensive conformity tests.
Nonetheless, errors cannot be entirely excluded.
The manufacturers shall not be liable for any di-
rect or indirect damage that may be caused by in-
correct handling, improper use, or any other
faulty behaviour on the part of a product. Poten-
tial hazards are mentioned in the relevant places
in the user information. Liability for loss of profit
shall be excluded in any case.
CE Marking
This certifies the conformity of the product
with the regulations which apply in accord-
ance with the directive R&TTE 1999/5/EC.
For a copy of the original signed declara-
tion (in full conformance with EN45014)
please contact the Regulatory Approvals
Manager at Mitel Networks Ltd., Castlegate
Business Park, Portskewett, Monmouth-
shire, NP26 5YR, United Kingdom.
Publicidad
