Operation Guidance; Remote Controller - Giatsu RA1A Manual De Usuario

Operation guidance

Installation batteries
1. Press the back side of remote controller marked with "
then push out the cover of battery box along the arrow direction.
2. Installation two 7# (AAA 1.5V) dry batteries, and make sure the positions of "+" polar and
"-" polar are correct.
3. Reinstall the cover of battery box.
Operation guidance
1.After connecting the power, press "
conditioner.
2.Press " " button to select your required mode: Auto, Cooling, Dry, Fan, Heating.
MODE
-
3.Press " " or "
adjusted under auto mode).
4.Press " FAN " button to set your required fan speed: auto, fan1, fan 2 , fan 3 , fan 4,
fan 5, stepless speed.
5.Press " " or "
NOTE:
● During operation, point the remote control signal sender at the receiving window on indoor unit.
● The distance between signal sender and receiving window should be no more than 8m, and there
should be no obstacles between them.
● Signal may be interfered easily in the room where there is fluorescent lamp or wireless telephone;
remote controller should be close to indoor unit during operation.
● Replace new batteries of the same model when replacement is required.
● When you don't use remote controller for a long time, please take out the batteries.
● If the display on remote controller is fuzzy or there's no display, please replace batteries.
" button to set your required temperature. (Temperature can't be
+
" button to select fan blowing angle.
" button on remote controller to turn on the air
1
", as shown in the picture,and