Safety Information - LF Utilitech PRO 6324-CAM Manual Del Usario

SAFETY INFORMATION

Please read and understand this entire manual before attempting to assemble, operate or install
the product.
WARNING
●
This light fixture is designed to fit standard junction boxes as defined by the National Electrical
Code.
●
To prevent electric shock, ensure that the power is disconnected before installation.
●
Consult a qualified electrician if you are not certain about the installation process. Always install
wiring connections in accordance with local code, ordinances and the National Electric Code.
●
Changes or modifications to this unit not expressly approved by the party responsible for
compliance could void the user's authority to operate the equipment.
●
Apart from installation or to access the memory card, do not attempt to open the unit as this may
invalidate your warranty.
●
Interference to other equipment or from other equipment may be caused by other such
equipment not being regulated correctly in order to avoid receiving or emitting interference.
NOTICE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver in
connected.
-Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules/Industry Canada license-exempt RSS
standard(s). Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and
(2) this device must accept any interference received, including interference that may cause
undesired operation.
MPE Requirements
To satisfy FCC/IC RF exposure requirements, a separation distance of 20 cm or more should be
maintained between the antenna of this device and persons during device operation.
To ensure compliance, operations at closer than this distance is not recommended.
Region Selection
Limited by local law regulations, version for North America does not have region selection option.
3