ClearSounds Photo 50 Manual Del Usuario página 7

Dialing using two-touch Memory Buttons
1 Lift the handset and wait for a dial tone.
2 Press the MEMORY key and memory location (0-9), the stored
telephone number will now be dialed.
flash
The FLASH button can be used to obtain a new dial tone after ending
a call. If you subscribe to Call Waiting or three-way calling from
your local phone company you can use the FLaSH button to switch
between calls.
Speakerphone
You can make outgoing or receive incoming calls by speakerphone.
Simply press the SpEaKErpHoNE button and the sound will be
switched to speaker. The Speakerphone LED will light.
You can adjust speaker volume by setting the right side speaker
volume control.
to switch between the handset and the
speakerphone.
While on a call using the handset, press the Speaker Button and
replace the handset in the cradle.
While on a call using the speakerphone, simply lift the handset.
Headset (headset not included)
You can plug a 2.5mm headset instead of the speakerphone or
handset mode.
To make outgoing calls and receive incoming calls, plug the headset
to the 2.5mm headset jack (located on the left side of the phone).
press the Speakerphone button to get a dial tone.
Note: When using the headset the call is not amplified
Shaker (Shaker not included)
at the rear of the phone, there is a 3.5mm shaker jack. You can
connect an optional shaker device. During ringing, the shaker will
vibrate to alert you.
anSWErInG MacHInE oPEratIon
The answering machine has to be turned on in order to receive
messages. When a call is received it will be answered after the
selected number of rings (see Answering machine set-up).
7 – ENGLISH